| 
SUPPORTS KTAG !
It can be safely* used to flash the engine ECU. Bosch EDC17C59 (installed in Opel vehicles) BOOT adapter L supports KTAG programmer. Precisly designed boot adapter for safe and friendly handlig that minimises the risk while connecting to Engine Control Unit pads.
Attention!
We offer 2 different dimensions of the adapter. This adapter is standard 6cm wide and it fits to standard BDM frame. Please be sure that you are looking the right one. If you own non standard BDM frame with 4cm wide socket for adapter fitting, than you can also get non standard 4cm wide adapter by clicking HERE.
No more tuning only over OBD, start real business and cover much more vehicles faster.
With adapter you can make full backup of the ECU in case that something goes wrong and you can than use that backup.
Technical specification
- supports KTAG programmer
- fits to classic BDM frame (this one is 6cm wide), if you need non standard 4cm wide adapter for non standard BDM frame, please click HERE
- supports stable and precise connection - with 2.5mm PCB there is no bending
- supports stable and reliable connection with precise golden pogopins
- very good impact resistance and nice handling with smooth PCB rounded edges
- usefull marking on the PCB
- ground and +12V pins are marked for led lights
- external 12 V power supply can be used for LEDs
- 3 LEDs for very good luminosity
- very important cut out edges very close around the pinouts for great view while connecting to the ECU
- cut out window at the middle of the adapter for better view on the ECU board
- clear view of the ECU pads simplifies positioning of the adapter- adapter width: 60mm
- adapter color: green with white print
- full package weight: 120g
- full package dimension: 5cm x 13cm x 9cm
- package color: gray or white
READY TO USE, ALL IS ALREADY SOLDERED AS ON THE PICTURE. PLUG AND PLAY.
Package content:
- adapter
- 1x red - power jumper Wires, premium Female/Female (21 x 300 mm)
- 1x black - power jumper Wires, premium Female/Female (21 x 300 mm)
- 3x jumper Wires for BOOT, CNF and YEL connection
Manual
- use users manual from KTAG programmer
Warnings:
Requires some basic knowledge for handling.
- be careful not to reverse polarity
- use only with 12V power supply
- do NOT make short circuit
- use only for mention purposes - reading and writing the ECU with 2 mentioned flashers/programmers
- do not bend the pogo pins
- do not eat
- do not burn
- do not expose it to heat or fire
- do not expose to the high voltage
- do not expose to direct sun light
- do not clean with chemicals
- pogo pins are very sharp and can make injuries
We do not take any responsibility (direct or indirect) for damages on your ECU by wrong usage, mistakes, accidents or any kind of interrupts, interference or coincidences (predictable or not predictable).
Howewer, our products are high quality products that will satisfy your needs and standards. Use it with care any you will never have problems |
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)