EDC17C59 BOOT ADAPTER BDM for KTAG size S (4cm wide)

VAT excluded

Price: 69,00 €


It can be safely* used to flash the ECU. Bosch EDC17C59 (installed in Opel vehicles) BOOT adapter L supports KTAG programmer. Precisly designed boot adapter for safe and friendly handlig that minimises the risk while connecting to Engine Control Unit pads.


We offer 2 different dimensions of the adapter. This adapter is 4cm wide and it fits to non-standard BDM frame (China frame). Please be sure that you are looking the right one. If you own standard BDM frame with 6cm wide socket for adapter fitting, than you can also get standard 6cm wide adapter by clicking HERE.

No more tuning only over OBD, start real business and cover much more vehicles faster.
With adapter you can make full backup of the ECU in case that something goes wrong and you can than use that backup.

Technical specification

- supports KTAG programmer
- fits to non-classic BDM frame - China frame (this one is 4cm wide), if you need standard 6cm wide adapter for standard BDM frame, please click HERE
- supports stable and precise connection - with 2.5mm PCB there is no bending
- supports stable and reliable connection with precise golden pogopins
- very good impact resistance and nice handling with smooth PCB rounded edges
- usefull marking on the PCB
- ground and +12V pins are marked for led lights
- external 12 V power supply can be used for LEDs
- 3 LEDs for very good luminosity
- very important cut out edges very close around the pinouts for great view while connecting to the ECU
- cut out window at the middle of the adapter for better view on the ECU board
- clear view of the ECU pads simplifies positioning of the adapter- adapter width: 40mm

- adapter color: green with white print

- full package weight: 120g

- full package dimension: 5cm x 13cm x 9cm
- package color: gray or white


Package content:

- adapter
- 1x red - power jumper Wires, premium Female/Female (21 x 300 mm)
- 1x black - power jumper Wires, premium Female/Female (21 x 300 mm)
- 3x jumper Wires for BOOT, CNF and YEL connection


- use users manual from KTAG programmer


Requires some basic knowledge for handling.

- be careful not to reverse polarity
- use only with 12V power supply
- do NOT make short circuit
- use only for mention purposes - reading and writing the ECU with 2 mentioned flashers/programmers
- do not bend the pogo pins
- do not eat
- do not burn
- do not expose it to heat or fire
- do not expose to the high voltage
- do not expose to direct sun light
- do not clean with chemicals
- pogo pins are very sharp and can make injuries

We do not take any responsibility (direct or indirect) for damages on your ECU by wrong usage, mistakes, accidents or any kind of interrupts, interference or coincidences (predictable or not predictable).

Howewer, our products are high quality products that will satisfy your needs and standards. Use it with care any you will never have problems